LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating EVAP Canister
    GM1637878Courtesy of GENERAL MOTORS CORP.
  1. Align the EVAP canister retaining feature to the canister bracket.
  2. Install the EVAP canister by sliding the canister towards the passenger side of the vehicle.
    3. Fig 2: Locating EVAP Canister Bolt
    GM1637877Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the EVAP canister bolt (1).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 3: Identifying EVAP Chassis Pipe Quick Connect Fitting
    GM1637876Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP chassis pipe quick connect fitting (1) to the canister. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 4: Identifying Fuel Fill Pipe Hose
    GM1636704Courtesy of GENERAL MOTORS CORP.
  5. Connect the fuel vent pipe quick connect fitting (4) to the canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the fresh air tube quick connect fitting (3) to the vent solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
    7. Fig 5: Identifying Fuel Tank Electrical Connector
    GM1636801Courtesy of GENERAL MOTORS CORP.
  7. Connect the EVAP canister vent solenoid valve electrical connector (2).
  8. Install the harness clip to the canister.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals