LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Valve Electrical Connector
    GM1625517Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly from the studs and reposition to the side.
  2. Disconnect the evaporative emission (EVAP) canister purge valve electrical connector (1).
    3. Fig 2: Identifying EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP canister purge valve tube from the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Disconnect the chassis EVAP vapor line from the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: Identifying EVAP Canister Purge Valve, Bracket & Bolt
    GM1578478Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP canister purge valve bracket bolt.
  6. Remove the EVAP canister purge valve with bracket.
  7. Remove the EVAP canister purge valve from the bracket.
  8. Inspect for carbon release in the EVAP canister purge valve ports. If there is any loose carbon, replace the EVAP canister and any components necessary to remove the carbon particles.
scientia non olet · About LEMON Manuals