LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Valve, Bracket & Bolt
    GM1578478Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the bracket.
  2. Position the EVAP canister purge valve with bracket to the cylinder head.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the EVAP canister purge valve bracket bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    4. Fig 2: Identifying EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve tube to the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: Identifying EVAP Canister Purge Valve Electrical Connector
    GM1625517Courtesy of GENERAL MOTORS CORP.
  6. Connect the EVAP canister purge valve electrical connector (1).
  7. Position the air cleaner assembly and install onto the studs.
scientia non olet · About LEMON Manuals