LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    NOTE: Inspect the CMP sensor for damage. Replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CMP Sensor Electrical Connector
    GM1639712Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake CMP sensor electrical connector (2).
  5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals