LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Position Actuator Solenoid Valve Electrical Connectors
    GM1647538Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Disconnect the intake (3) or exhaust (2) camshaft position actuator solenoid valve electrical connector, as required.
    3. Fig 2: Identifying CMP Actuator Solenoid Valve
    GM1578482Courtesy of GENERAL MOTORS CORP.
  3. Remove the exhaust (1) camshaft position (CMP) actuator solenoid valve bolt and valve, as required.
  4. Remove the intake (2) CMP actuator solenoid valve bolt and valve, as required.
  5. Inspect the solenoid valve O-ring seals from damage, replace as necessary.
scientia non olet · About LEMON Manuals