LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L Or 2.4L - Introduction) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying PCV Hose
    GM1721513Courtesy of GENERAL MOTORS CORP.
  1. Gently lift up the rear of the air cleaner assembly in order to disengage the air cleaner from the studs.
  2. Reposition the air cleaner assembly in order to access the positive crankcase ventilation (PCV) hose and the throttle body duct.
  3. Reposition the PCV hose clamp (1) at the air cleaner assembly.
  4. Remove the PCV hose (2) from the air cleaner assembly.
    5. Fig 2: Identifying Air Cleaner Assembly
    GM1638524Courtesy of GENERAL MOTORS CORP.
  5. Loosen the air cleaner outlet duct clamp at the throttle body.
    6. Fig 3: Identifying MAF Sensor Electrical Connector
    GM1625474Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the engine wiring harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
  7. Remove the air cleaner assembly.
scientia non olet · About LEMON Manuals