LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Roller Followers
    GM758358Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft. Refer to Intake Camshaft and Valve Lifter Replacement  or Exhaust Camshaft and Valve Lifter Replacement .
  2. Remove the spark plugs. Refer to Spark Plug Replacement .
  3. Remove the camshaft roller followers.
    4. Fig 2: View Of J 43649 Valve Spring Compressor (Second Camshaft Cover Bolt Hole)
    GM1675266Courtesy of GENERAL MOTORS CORP.
  4. Install the front section of the J 43649  to the second camshaft cover bolt hole.
    5. Fig 3: View Of J 43649 Valve Spring Compressor (Cylinder Head)
    GM1675271Courtesy of GENERAL MOTORS CORP.
  5. Install the remaining parts of the J 43649  to the cylinder head.
    6. Fig 4: View Of Air Hose Adaptor
    GM758363Courtesy of GENERAL MOTORS CORP.
  6. Install an air hose adapter into the spark plug hole.
  7. Attach an air hose to the adapter
  8. Using the compressed air, pressurize the cylinder to 690 kPa (100 psi).
  9. Compress the valve spring using the J 43649  .
    10. Fig 5: Identifying Valve Spring Keepers
    GM1403900Courtesy of GENERAL MOTORS CORP.
  10. Remove the valve spring keepers.
  11. Remove the valve spring retainer.
    12. Fig 6: Identifying Valve Springs
    GM1403902Courtesy of GENERAL MOTORS CORP.
  12. Remove the valve spring.
    13. Fig 7: View Of Special Tool J 36017 & Valve Seal
    GM758364Courtesy of GENERAL MOTORS CORP.
  13. Using the J 36017  remove the valve seal.
scientia non olet · About LEMON Manuals