LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Piston Oil Nozzle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Piston Oil Nozzle Assembly
    GM1594334Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install new piston oil nozzles. Turn the extension by hand to ensure that the threads are aligned. Use a long screwdriver to ensure that the nozzle does not rotate and make sure that the locating pin is properly indexed in its hole. Tighten the piston oil nozzle bolts to 15 N.m (11 lb ft).
  2. Install the engine oil pan. Refer to Oil Pan Replacement .
  3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Replace the oil filter and fill the engine with new engine oil. Refer to Engine Mechanical Specifications (2.2L)  or Engine Mechanical Specifications (2.4L) .
  5. Reset the engine oil life monitor. Refer to GM Oil Life System Resetting .
scientia non olet · About LEMON Manuals