LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Engine Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Mount Bracket
    GM1623162Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount bracket to the engine.
  2. Install the engine mount bracket bolts in the following locations:
    • The long bolts in the forward and lower rear holes
    • The short bolt in the upper rear hole
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the engine mount bracket bolts in the following sequence.
    1. Upper rear
    2. Lower rear
    3. Forward

      Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement .
scientia non olet · About LEMON Manuals