LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accessing Drive Belt Tensioner Bolt
    GM1717781Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
  2. Insert a pry bar between the engine and the cradle, and raise the engine slightly until a socket with an extension can be installed onto the drive belt tensioner bolt.
    3. Fig 2: View Of Drive Belt Tensioner
    GM1571145Courtesy of GENERAL MOTORS CORP.
  3. Remove the drive belt tensioner bolt.
  4. Remove the drive belt tensioner.
scientia non olet · About LEMON Manuals