LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner
    GM1571145Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt tensioner.
  2. Insert a pry bar between the engine and the cradle, and raise the engine slightly until the drive belt tensioner bolt can be installed.
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the drive belt tensioner bolt.

    Tighten:  Tighten the bolt to 45 N.m (33 lb ft).

  4. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals