LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Special Tool J 44811 Installed To Drive Belt Tensioner
    GM1717758Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine splash shield. Refer to Engine Splash Shield Replacement .
  2. Install the J 44811  to the drive belt tensioner. See Special Tools .
  3. Using the J 44811  , rotate the drive belt tensioner counter clockwise in order to release the spring tension. See Special Tools .
    4. Fig 2: View Of Drive Belt
    GM1571093Courtesy of GENERAL MOTORS CORP.
  4. Remove the drive belt from under the drive belt tensioner.
  5. Remove the drive belt from around the accessory drive pulleys.
  6. Remove the drive belt.
  7. Using the J 44811  , rotate the drive belt tensioner clockwise in order to release the spring tension. See Special Tools .
scientia non olet · About LEMON Manuals