LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt
    GM1571093Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt around all the accessory drive pulleys, except for the drive belt tensioner.
    2. Fig 2: View Of Special Tool J 44811 Installed To Drive Belt Tensioner
    GM1717758Courtesy of GENERAL MOTORS CORP.
  2. Using the J 44811  , rotate the drive belt tensioner counter clockwise in order to release the spring tension. See Special Tools .
  3. Position the drive belt under the drive belt tensioner.
  4. Using the J 44811  , rotate the drive belt tensioner clockwise in order to release the spring tension. See Special Tools .
  5. Remove the J 44811  from the drive belt tensioner. See Special Tools .
  6. Ensure that the drive belt is properly aligned on the accessory drive pulleys.
  7. Install the engine splash shield. Refer to Engine Splash Shield Replacement .
scientia non olet · About LEMON Manuals