LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Cover & Bolts
    GM1578306Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the camshaft cover and bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    2. Fig 2: Identifying Engine Harness Clips
    GM1631141Courtesy of GENERAL MOTORS CORP.
  2. Install the ignition coils. Refer to Ignition Coil Replacement .
  3. Install the engine harness clips (1,2 ) to the cover.
    4. Fig 3: Identifying Ignition Coil Electrical Connectors
    GM1628020Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake (2) and exhaust (1) camshaft position actuator solenoid valve electrical connectors.
    5. Fig 4: Identifying PCV Hose
    GM1631138Courtesy of GENERAL MOTORS CORP.
  5. Install the PCV hose to the cover.
  6. Position the PCV hose clamp.
  7. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals