LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - Off Vehicle >> Engine Flywheel Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It may be necessary to remove the chamfer (bevel) from the edge of an 18 mm socket in order to get full socket engagement on the thin headed flywheel bolts.
    Do not orientate the flywheel to the crankshaft. It is balanced separately from the engine.
  1. Remove the flywheel attaching bolt. Use the J 38122-A  to prevent crankshaft rotation. See Special Tools .
    2. Fig 2: Identifying Flywheel & Retaining Bolts
    GM412117Courtesy of GENERAL MOTORS CORP.
  2. Remove the flywheel, if the vehicle has a manual transmission.
    3. Fig 3: View Of Flywheel
    GM412119Courtesy of GENERAL MOTORS CORP.
  3. Remove the flywheel retainer for vehicles with automatic transmission.
  4. Remove the flywheel, if the vehicle has an automatic transmission.
  5. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
scientia non olet · About LEMON Manuals