LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - Off Vehicle >> Engine Flywheel Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View of The Flywheel With Manual Transmission
    GM2146394Courtesy of GENERAL MOTORS CORP.
  1. Install the flywheel (1) for vehicles with manual transmission.
  2. Install the NEW bolts.
    3. CAUTION: Refer to Fastener Caution .
    NOTE: EN-43653:  flywheel holding tool may be used instead of EN-38122-A:  holder in order to prevent crankshaft rotation.
  3. Holding the crankshaft balancer with EN-38122-A:  holder, tighten the bolts evenly. Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the EN-45059:  meter
    4. Fig 2: View of The Flywheel With Automatic Transmission
    GM2148402Courtesy of GENERAL MOTORS CORP.
  4. Install the flywheel (1) for vehicles with automatic transmission.
  5. Install the NEW bolts.
    6. CAUTION: Refer to Fastener Caution .
    NOTE: EN-43653:  flywheel holding tool may be used instead of EN-38122-A:  holder in order to prevent crankshaft rotation.
  6. Holding the crankshaft balancer with EN-38122-A:  holder, tighten the bolts evenly. Tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees using the EN-45059:  meter
scientia non olet · About LEMON Manuals