LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - Off Vehicle >> Cylinder Head Disassemble >> Disassembled View Of

Disassembled View Of

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying the Coolant Air Bleed Hose Fitting
    GM2128103Courtesy of GENERAL MOTORS CORP.
  1. Remove the coolant air bleed hose fitting (1).
    2. Fig 2: Identifying Valve Keys & Retainer
    GM2148527Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure that the valve train components are kept together and identified in order for proper re-installation in their original position.
  2. Using the EN-8062:  compressor and the EN-43963:  compressor (off car), compress the valve spring.
  3. Remove the valve keys (1).
  4. Slowly release the EN-8062:  compressor and the EN-43963:  compressor (off car) from the valve spring assembly.
  5. Remove the retainer (2).
    6. Fig 3: View of Valve Springs
    GM2148529Courtesy of GENERAL MOTORS CORP.
  6. Remove the springs (1).
    7. Fig 4: View of Valve Seals
    GM2148530Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not damage the valve guide. Remove any burrs that have formed at the key groove by chamfering the valve stem with an oil stone or a file.
  7. Remove the valve seals (1). Use the EN-36017:  remover. Do not reuse.
    8. Fig 5: Identifying Valves
    GM2148531Courtesy of GENERAL MOTORS CORP.
  8. Remove the valves (1).
    9. Fig 6: Identifying Cylinder Head Plugs
    GM2128104Courtesy of GENERAL MOTORS CORP.
  9. Remove the cylinder head plugs (1).
scientia non olet · About LEMON Manuals