LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - Off Vehicle >> Crankshaft Rear Oil Seal Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Rear Oil Seal & Special Tool J 42067
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Remove excess sealer from seal recess.
  2. Lubricate the outside diameter of the new crankshaft seal with clean engine oil.
  3. Using the J 42067  , press the new crankshaft seal into the housing. The J 42067  also establishes the depth of the seal in the crankshaft seal bore.
scientia non olet · About LEMON Manuals