LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L Or 2.4L) >> Repair Instructions - Off Vehicle >> Crankshaft Balancer Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Special Tool J 38122-A
    GM2148293Courtesy of GENERAL MOTORS CORP.
    NOTE: EN-43653:  flywheel holding tool may be used instead of EN-38122-A:  crankshaft balancer holder to prevent crankshaft rotation.
  1. Install EN-38122-A:  holder (1).
  2. Remove the balancer retaining bolt and washer. Use EN-38122-A:  holder and a breaker bar to prevent the crankshaft from rotating when loosening the bolt. Discard the bolt.
    3. Fig 2: Identifying Balancer
    GM2148366Courtesy of GENERAL MOTORS CORP.
  3. Remove the crankshaft balancer assembly (1) using a universal removal tool.
scientia non olet · About LEMON Manuals