Cleaning Gasket Surfaces

WARNING: This page is about a different variant/trim than selected.

Remove all gasket and sealing material from the part using the J 28410 or equivalent.
Care must be used to avoid gouging or scraping the sealing surfaces.
Do not use any other method or technique to remove sealant or gasket material from a part.
Do not use abrasive pads, sand paper, or power tools to clean the gasket surfaces.
- These methods of cleaning can cause damage to the component sealing surfaces.
- Abrasive pads also produce a fine grit that the oil filter cannot remove from the oil.
- This grit is abrasive and has been known to cause internal engine damage.