LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate a new O-ring with DEXRON III transmission fluid.
  2. Install the new O-ring.
    3. Fig 1: Identifying VSS Retainer
    GM12407Courtesy of GENERAL MOTORS CORP.
  3. Install the VSS assembly.
  4. Install the VSS retainer.
    5. CAUTION: Refer to Fastener Caution .
    Fig 2: View Of VSS Retainer Bolt
    GM623141Courtesy of GENERAL MOTORS CORP.
  5. Install the VSS retainer bolt.

    Tighten:  Tighten the bolt to 12 N.m (8 lb ft).

    6. Fig 3: View Of Connecting VSS Connector To VSS
    GM12406Courtesy of GENERAL MOTORS CORP.
  6. Connect the VSS connector to the VSS.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals