LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Remove the wheel driveshaft. Refer to Wheel Drive Shaft Replacement .
    4. Fig 1: Identifying Front Wheel Drive Shaft Oil Seal Removal Tool J 44809
    GM863208Courtesy of GENERAL MOTORS CORP.
  4. Use the J 23907  in order to remove the seal.
  5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.
scientia non olet · About LEMON Manuals