LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions - On Vehicle >> Backup Lamp Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.
  1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
  2. Disconnect the backup lamp connector (1).
    3. Fig 1: Locating Backup Light Connector & VSS Connector
    GM857190Courtesy of GENERAL MOTORS CORP.
  3. Remove the backup lamp switch assembly.
scientia non olet · About LEMON Manuals