Installation Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

Fig 1: Locating Backup Light Connector & VSS Connector

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the backup lamp switch using pipe sealant. For the sealant part number, refer to Adhesives, Fluids, Lubricants, and Sealers .
Tighten: Tighten the switch to 33 N.m (24 lb ft).
Connect the backup lamp connector (1).
Install the left front wheel. Refer to Tire and Wheel Removal and Installation .