LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - GETRAG 5 Speed) >> Diagnostic Information and Procedures >> DTC P0806 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector of the CPP sensor.
  2. Measure the resistance between the signal terminal B and the low reference terminal A of the CPP sensor. Sweep the CPP sensor through the entire range. The resistance should vary low to high and high to low without any spikes or dropouts.
    • If the resistance is erratic with spikes or dropouts, replace the CPP sensor.
scientia non olet · About LEMON Manuals