LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 2.2L Or 2.4L - DTC P0351 To DTC P2544) >> DTC P2120, P2122, P2123, P2125, P2127, P2128, or P2138 (2.2L) >> Circuit/System Verification (2.2L)

Circuit/System Verification (2.2L)

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, observe the scan tool APP sensor 1 voltage parameter. The reading should be between 0.13-4.87 volts and change with accelerator pedal input.
  2. Ignition ON, observe the scan tool APP sensor 2 voltage parameter. The reading should be between 0.13-4.87 volts and change with accelerator pedal input.
  3. Ignition ON, observe the scan tool APP Sensor 1 and 2 parameter. The scan tool should indicate agree.
  4. Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC, or within the conditions that you observed from the Freeze Frame/Failure Records.
  5. Verify that DTC P2120 or P2125 are not the only accelerator pedal position DTCs set.
    • If DTC P2120 or P2125 are the only DTCs set, replace the ECM.
  6. Verify that DTCs P0641 or P0651 are set.
scientia non olet · About LEMON Manuals