LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Transaxle Oil Cooler Pipe
    GM1523656Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle oil cooler pipes to the vehicle.
  2. Install the transaxle oil cooler pipes to the fittings at the radiator.
  3. Install the transaxle oil cooler pipe to the retaining clip at the radiator.
    4. Fig 2: View Of Transaxle Oil Cooler Pipes
    GM1523657Courtesy of GENERAL MOTORS CORP.
  4. Install the transaxle oil cooler pipes to the transaxle.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the transaxle oil cooler pipe retaining nut.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  6. Remove the drain pan.
  7. Lower the vehicle.
    8. NOTE: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  8. Adjust the transmission fluid level. Refer to Transmission Fluid Check .
  9. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals