LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal and Output Shaft Sleeve Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left drive axle assembly. Refer to Wheel Drive Shaft Replacement .
    3. Fig 1: Locating Drive Axle Retaining Clip
    GM1873863Courtesy of GENERAL MOTORS CORP.
  3. Remove the snap ring from axle. Discard the snap ring. Do not reuse.
    4. Fig 2: View Of Case Cover Seal
    GM1873862Courtesy of GENERAL MOTORS CORP.
  4. Remove the output axle seal.
    5. Fig 3: Using Special Tool To Remove Sleeve From Output Axle Shaft
    GM569234Courtesy of GENERAL MOTORS CORP.
  5. Use the J 41227  to remove the sleeve from the output axle.
scientia non olet · About LEMON Manuals