LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Control Valve Body Cover Gasket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Side Cover Gaskets & Thrust Washer
    GM20822Courtesy of GENERAL MOTORS CORP.
  1. Install the side cover gaskets (5 and 6) into the grooves on the side cover (1).
  2. Retain the seals with J 36850  or equivalent.
  3. Install the side cover to drive sprocket thrust washer (7) onto the side cover.
  4. Retain the thrust washer with J 36850  or equivalent.
  5. Install the transmission side cover. Refer to Control Valve Body Cover Replacement .
scientia non olet · About LEMON Manuals