LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Wiring Harness Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Compressing Pass-Through Connector's Retaining Tabs With Special Tool J 41101
    GM55101Courtesy of GENERAL MOTORS CORP.
  1. Push the J 41101:  remover or equivalent onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs.
  2. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
  3. Remove the wiring harness (11).
scientia non olet · About LEMON Manuals