Assembly Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Special Tool J 41102

Courtesy of GENERAL MOTORS CORP.

NOTE: You must use the J 41102-1A: seal installer in order to install the seal correctly. The J 41102-1A: seal installer installs the axle seal to a given depth.

Install a new right hand axle seal (2) into the transmission case. Use the J 41102-1A: seal installer with the J 8092: driver handle.
In order to prevent damage to the shaft splines during vehicle operation, add Polyurea grease (part number 7843867) to the splines on the output shaft.