LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Reaction Internal Gear, Input Carrier Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Reaction Internal Gear & Input Carrier Assembly
    GM20254Courtesy of GENERAL MOTORS CORP.
  1. Assemble the input carrier assembly (562) to the reaction internal gear (560.
  2. Retain the input carrier assembly with the snap ring (563).
  3. Assemble the thrust bearing (107) onto the input carrier assembly.
  4. Retain the thrust bearing with J 36850:  lubricant or equivalent. You will find another thrust bearing permanently retained in the input carrier assembly (562).
scientia non olet · About LEMON Manuals