LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Output Shaft Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Output Shaft Snap Ring
    GM479779Courtesy of GENERAL MOTORS CORP.
  1. Remove the snap ring (57).
    2. Fig 2: Identifying Special Tools J 6125-1B & J 38868 On Output Shaft
    GM1644720Courtesy of GENERAL MOTORS CORP.
  2. Install the J 6125-1B:  slide hammer with adapter and J 38868:  remover and installer on the output shaft (94).
scientia non olet · About LEMON Manuals