LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Manual Shift Shaft Pin, Detent Lever, and Park Pawl Actuator Assembly Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Manual Shaft Seal
    GM20220Courtesy of GENERAL MOTORS CORP.
  1. Install a new manual shaft seal (809) into the case (51). Use a 13 mm socket.
    2. Fig 2: Identifying Manual Shaft Pin & Special Tool J 41229
    GM20221Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.
  2. Install the manual shaft pin (803) into the case. Use the J 41229:  pin installer or equivalent.
    3. Fig 3: View Of Parking Lock Actuator Assembly, Manual Shaft & Detent Lever Assembly
    GM20209Courtesy of GENERAL MOTORS CORP.
  3. With the manual valve to detent lever link (802) and the parking lock actuator assembly (807) attached, install the manual shaft and detent lever assembly (806) into the case.
  4. Ensure that the parking lock actuator rod is correctly positioned into the actuator guide.
scientia non olet · About LEMON Manuals