LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Intermediate Fourth Band Assembly Installation

Intermediate Fourth Band Assembly Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Intermediate Fourth Band Assembly
    GM1644730Courtesy of GENERAL MOTORS CORP.
  1. Assemble a new Intermediate/Fourth band (100) into the transmission case.
    2. Fig 2: Verifying Proper Positioning Of Intermediate/Fourth Band
    GM474255Courtesy of GENERAL MOTORS CORP.
  2. In order to verify the proper positioning of the band, insert a screwdriver through the Intermediate/Fourth servo bore. The screwdriver should press on the servo pin rest and compress the band around the reverse clutch housing.
scientia non olet · About LEMON Manuals