LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Final Drive and Differential Assembly Install >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Final Drive & Differential Assembly
    GM20234Courtesy of GENERAL MOTORS CORP.
  1. Install the final drive carrier to case thrust bearing (117) onto the final drive carrier. Retain the bearing with J 36850:  lubricant.
  2. Install the complete final drive carrier assembly (116) into the transmission case (51).
  3. Install the thrust bearing (700) into the final drive carrier assembly (116). Retain the bearing with J 36850:  lubricant.
    4. NOTE: Install the sun gear with the grooved side up (flat side down).
  4. Install the final drive sun gear (115) into the final drive carrier (116).
scientia non olet · About LEMON Manuals