LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Drive Sprocket Support Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying 2nd Clutch Piston & Seal Assembly
    GM55132Courtesy of GENERAL MOTORS CORP.
  1. In order to aid in the assembly, lubricate the seal with transmission fluid.
  2. Assemble the 2nd clutch piston and seal assembly (404) into the driven sprocket support (401).
  3. Assemble the 2nd clutch spring and retainer assembly (405) into the driven sprocket support.
    4. Fig 2: View Of 2nd Clutch Spring Retainer Snap Ring
    GM55129Courtesy of GENERAL MOTORS CORP.
  4. Compress the 2nd clutch spring assembly. Use the J 41232:  spring compressor and J 23327:  spring compressor or equivalent.
  5. Assemble the 2nd clutch spring retainer snap ring (406).
  6. Remove the J 41232:  spring compressor and J 23327:  spring compressor.
    7. Fig 3: Locating Seal Rings On Driven Sprocket Support
    GM55134Courtesy of GENERAL MOTORS CORP.
  7. Assemble two new seal rings (403) onto the driven sprocket support.
scientia non olet · About LEMON Manuals