LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Automatic Transmission Fluid Pan and Gasket Installation

Automatic Transmission Fluid Pan and Gasket Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pan Gasket
    GM25657Courtesy of GENERAL MOTORS CORP.
  1. Inspect the oil pan (88) for cracks, dents or damage to the gasket sealing surface.
  2. Inspect the gasket (87) for cuts or other damage. The bottom pan gasket is reusable if not damaged.
  3. Clean and dry the bottom pan, gasket and magnet (89).
    4. Fig 2: View Of Bottom Pan & Gasket
    GM20163Courtesy of GENERAL MOTORS CORP.
  4. Install the gasket (87) and bottom pan (88) onto the transmission case.
    5. Fig 3: Identifying Bottom Pan Bolt Locations
    GM20837Courtesy of GENERAL MOTORS CORP.
  5. Install the twelve bottom pan bolts (81).
    6. Fig 4: Identifying Bottom Oil Pan Bolts
    GM20323Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  6. Hand start the bolts. Tighten the bottom pan bolts to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals