Front Seat Back Recliner Outer Trim Panel Replacement

Fig 1: Identifying Front Seat Back Recliner Outer Trim Panel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the recliner handle. Refer to Driver or Passenger Seat Recliner Handle Replacement .
1	Seat Back Cushion Latch Release Handle
2	Seat Recliner Finish Cover Screw CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
3	Seat Recliner Finish Outboard Bottom Cover Tip: Unclip the rear of the cover first then pull away from the front side of the seat to remove.
4	Seat Recliner Finish Cover Screw Tighten: 2 N.m (18 lb in)
5	Seat Recliner Finish Outboard Top Cover Tip: Unclip the rear of the cover first then pull away from the front side of the seat to remove.