LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the transmission side cover. Refer to Control Valve Body Cover Replacement .
  2. Remove the control valve body. Refer to Control Valve Body Replacement .
    3. Fig 1: Compressing Pass-Through Connector's Retaining Tabs With J 41101
    GM55101Courtesy of GENERAL MOTORS CORP.
  3. Push the J 41101  onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs. See Special Tools .
  4. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
  5. Remove the wiring harness (11).
scientia non olet · About LEMON Manuals