LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Torque Converter Assembly Removal

Torque Converter Assembly Removal

    Fig 1: Identifying Torque Converter & Turbine Shaft O-Ring
    GM20155Courtesy of GENERAL MOTORS CORP.
    WARNING: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.
  1. Remove the torque converter assembly (55).
  2. Remove the turbine shaft 0-ring (41) from the end of the turbine shaft.
scientia non olet · About LEMON Manuals