LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Channel Plate Assembly Assemble >> Assembly Procedure

Assembly Procedure

    Fig 1: Identifying Accumulator Piston Seals
    GM55115Courtesy of GENERAL MOTORS CORP.
  1. Assemble the new accumulator piston seals (30) on the three accumulator pistons (29).
  2. Install the 1-2 and 2-3 accumulator assist springs (47, 125).
  3. Install the accumulator pistons (29) into the channel plate over the guide pins. The pistons are identical. You can assemble the pistons in any of the three accumulator bores.
  4. In order to retain the pistons, apply J 36850:  lubricant onto the piston seals.
  5. Install the manual valve (800) into channel plate.
scientia non olet · About LEMON Manuals