LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Torque Converter Installation >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Torque Converter & Turbine Shaft O-Ring
    GM20155Courtesy of GENERAL MOTORS CORP.
  1. Install a new turbine shaft O-ring (41) on the end of the turbine shaft.
    2. WARNING: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.
  2. Install the torque converter onto the transmission.
  3. Install the J 21366:  holding strap.
  4. Remove the transmission from the holding fixture.
scientia non olet · About LEMON Manuals