LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> HHR LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Channel Plate Assembly Installation >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Channel Plate Assembly & Components
    GM474268Courtesy of GENERAL MOTORS CORP.
  1. Install the channel plate to drive sprocket thrust washer (34) onto the channel plate (27).
  2. Retain the thrust washer (34) with J 36850:  lubricant or equivalent.
  3. Install a new channel plate to case gasket (28) onto the transmission case (51).
  4. Install the channel plate assembly onto the transmission case (51). The channel plate should fit tightly over the guide pins (45) located on the transmission case (51).
    5. CAUTION: Refer to Fastener Caution .
  5. Install the two channel plate to driven sprocket support bolts (25). Tighten the two channel plate to driven sprocket bolts (25) to 14 N.m (10.5 lb ft).
    6. Fig 2: Identifying Channel Plate Assembly Bolts
    GM571023Courtesy of GENERAL MOTORS CORP.
  6. Install the six channel plate to case bolts (25). Hand tighten the bolts. Tighten the six channel plate to case bolts and the two channel plate to driven sprocket support bolts to 12 N.m (9 lb ft).
scientia non olet · About LEMON Manuals