LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch System) >> Repair Instructions >> Hydraulic Clutch Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Clutch Actuator Cylinder
    GM180855Courtesy of GENERAL MOTORS CORP.
  1. Remove the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement .
  2. Use a small drift or punch to remove the roll-pin retaining the hydraulic hose to the actuator cylinder.
    3. Fig 2: View Of Hydraulic Hose & Actuator Cylinder
    GM180856Courtesy of GENERAL MOTORS CORP.
  3. Remove the hydraulic hose from the actuator cylinder.
  4. Drain off the excess fluid from the actuator cylinder into a container.
scientia non olet · About LEMON Manuals