Clutch Pedal Position Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Disconnect the clutch pedal position switch electrical connector. |
|
| 1 | Clutch Pedal Position Switch Bolt
CAUTION:
Refer to Fastener Caution
.
Tighten: 2.5 N.m (22 lb in) |
| 2 | Clutch Pedal Position Switch Procedure:
WARNING:
Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged. Perform a sensor learn. Refer to Clutch Pedal Position Sensor Learn . |