LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Transmission Fluid Level Inspection

Transmission Fluid Level Inspection

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transmission Fluid Fill Plug
    GM1859350Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle; ensure that the vehicle is level. Refer to Lifting and Jacking the Vehicle .
  2. Clean any dirt from around the fill plug hole.
  3. Remove the transmission fluid fill plug.
  4. Inspect the transmission fluid level. Ensure that the fluid level is even with the bottom of the fill plug hole.
  5. Add transmission fluid, if necessary. Refer to Transmission Fluid Replacement .
    6. Fig 2: View Of Transmission Fluid Fill Plug
    GM1859350Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  6. Install the transmission fluid fill plug hole.

    Tighten:  Tighten the transmission fluid fill plug hole to 27 N.m (20 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals