LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Install a drain pan under the vehicle.
  3. Fig 1: View Of Upper & Lower Transmission Oil Cooler Lines At Intermediate Lines
    GM1503871Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the upper transmission oil cooler line from the upper intermediate line. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  5. Disconnect the lower transmission oil cooler line from the lower intermediate line. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  6. Fig 2: Identifying Front Upper & Lower Transmission Lines Clip
    GM1503873Courtesy of GENERAL MOTORS CORP.
  7. Remove the clip holding the front upper and lower transmission lines.
  8. Fig 3: Identifying Upper & Lower Transmission Oil Cooler Lines At Radiator
    GM1503922Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the upper transmission oil cooler line from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  10. Disconnect the upper transmission oil cooler line from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  11. Remove the engine mount. Refer to Engine Mount Replacement - Right Side .
  12. Fig 4: Identifying Transmission Oil Cooler Lines & Bolts
    GM1503860Courtesy of GENERAL MOTORS CORP.
  13. Remove the front transmission oil cooler line bolts.
  14. Remove the front transmission oil cooler lines from the vehicle.