LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Shift Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Roll Pin, Transmission Shift Rod & Transmission Shift Shaft
    GM71536Courtesy of GENERAL MOTORS CORP.
  1. Remove the shift control assembly. Refer to Shift Control Assembly Replacement .
  2. Remove the driveline support assembly, the transmission and the differential from the vehicle, then separate the transmission from the driveline support assembly. Refer to Driveline Support Assembly Replacement .
  3. Slide the transmission shift rod toward the transmission until the transmission shift shaft seats in the rear-most detent position.

    Placing the shift rod close to the transmission housing provides additional support for the transmission shift shaft.

  4. Using a drift or punch, remove the roll pin (1) retaining the transmission shift rod to the transmission shift shaft.
  5. Remove the transmission shift rod from the transmission shift shaft.
scientia non olet · About LEMON Manuals