LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Shift Linkage Adjustment

Shift Linkage Adjustment

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Shift Control Neutral Lock Pin
    GM180811Courtesy of GENERAL MOTORS CORP.
  1. Apply the parking brake.
  2. Remove the shift control closeout boot. Refer to Shift Control Shift Closeout Boot Replacement .
  3. Place the shifter into NEUTRAL.
  4. Press down to engage the shift control neutral lock pin.
    5. Fig 2: Identifying Transmission Shift Rod, Clamp & Bolt
    GM71526Courtesy of GENERAL MOTORS CORP.
  5. Loosen the transmission shift rod clamp bolt.
  6. Loosen the shift control mounting bolts.
  7. Check that the shift control locator (on the underside of the shift control) is installed into the shifter bracket on the side of the driveline support assembly.
    8. CAUTION: Refer to Fastener Caution .
  8. Tighten the shift control mounting bolts.

    Tighten:  Tighten the shift control mounting bolts to 30 N.m (22 lb ft).

  9. Tighten the transmission shift rod clamp bolt.

    Tighten:  Tighten the transmission shift rod clamp bolt to 30 N.m (22 lb ft).

    10. Fig 3: Releasing Shift Control Neutral Lock Pin
    GM180816Courtesy of GENERAL MOTORS CORP.
  10. Lift to release the shift control neutral lock pin.
  11. Install the shift control closeout boot. Refer to Shift Control Shift Closeout Boot Replacement .
  12. Release the parking brake.
scientia non olet · About LEMON Manuals